How To Replace A Window Pane In A Metal Frame
Take the new drinking glass cut so it measures ane/8 inch shorter than the exact groove dimensions in both the length and width. This creates a 1/xvi-inch gap on each side between the edges of the pane and the rabbet groove. The gap provides room for the glass to expand when the weather changes.
In addition to the replacement glass pane, you'll need: latex glazing putty, pliers, estrus gun, flexible putty knife, 1- or two-inch strong steel putty knife, and a flathead screwdriver.
Utilise the pliers to remove all of the glass shards.
When you work with cleaved glass, wear safety goggles too as gloves; small fries of glass can crusade permanent eye damage.
Use the heat gun to warm the old putty; and then scrape information technology away with a putty knife.
If the putty doesn't lift off hands, apply more than heat and endeavor over again. Be patient —the putty around really sometime windows is every bit difficult as concrete, merely it will soften.
Don't chisel out the old putty — you might wreck the window. The putty volition soften with enough heat and time.
Use a putty pocketknife or the tip of a screwdriver to remove the leap clips.
The clips will exist cached nether the old putty. Hold on to these clips so that you can utilize them once more.
Clean and inspect the rabbet groove.
Ensure that no glazing putty, glass shards, or leap clips remain.
Apply a bead of putty on the drinking glass side of the rabbet groove.
Clasp out a 1⁄16-inch bead of putty between the edge of the glass and the window frame.
Gently press downward the glass at the edges to bed the glass into the putty.
Allow the putty bed to spread out and class a moisture seal on the inside of the window between the glass and sash.
Position the new pane in the rabbets.
Shift the pane until y'all take a 1/16-inch gap between the pane and sash on all 4 sides.
Place at least two spring clips in each section of the window sash surrounding the new glass.
Infinite the spring clips (the ones that you removed before) evenly around the perimeter,
Push each spring clip into the sash.
You lot can apply the tip of a screwdriver to help push in the spring clip.
Course a 1/ii-inch-thick rope of putty and printing the length forth all 4 sides of the glass.
Coil a glob of putty between your blank easily to form the rope.
Smooth the glazing putty and scrape away the excess.
Hold the putty pocketknife at a 45-degree angle, press, and smooth the glazing putty against the glass and sash.
After the putty dries completely, repaint the putty and repaired area.
Don't mask off the drinking glass before repainting. The pigment will help class a moisture seal between the glass pane and the sash. Then, allow the paint to overlap about one/8 inch onto the glass.
Most This Article
This article can be plant in the category:
- Windows ,
Source: https://www.dummies.com/home-garden/interiors/how-to-replace-a-broken-glass-pane-in-a-steel-casement-window/
Posted by: williamswaregs.blogspot.com
0 Response to "How To Replace A Window Pane In A Metal Frame"
Post a Comment